RS-485 BoosterPack skarg
An RS-485 BoosterPack for TI Launchpad boards. Uses through hole compenents.
- skarg created — 4 years ago
This project does not have a descriptive photograph.
An RS-485 BoosterPack for TI Launchpad boards. This project layout uses through hole components for easy project building. The circuit includes an RS-485 transceiver and two LEDs. The board was designed for use with BACnet MS/TP, but could be used with any RS-485 protocol. The RS-485 terminal includes A+, B-, and a ground reference pin (3-wire). The reference pin is connected via a resistor to the RS-485 transceiver ground.
This project does not have a schematic diagram.
This project does not have a board layout.
Bill of Materials
This project does not have a bill of materials.
This project is © Steve Karg, and is published under the terms of the Creative Commons Attribution 3.0 Unported licence.